Replacing Broken Garage Door Springs

When your garage door is not working due to a broken garage door spring, it should be repaired or replaced immediately. You can either hire a professional garage door services to deal with it or handle the garage door spring repair project on your own.

These are the long and heavy components that are created from steel. These are installed to aid the opening and closing operations of a garage door. If you are facing the problems of broken garage door springs that need to be taken care of immediately, the following are the steps to get the job done. These procedures will help you to accomplish your task easily and safely.  

The first important thing that you need to remember is to make sure that you have turned off the electric supply to the motor so there is no chance of getting electrocuted while performing a fixing job. It is also good to double-check that you have disconnected the power cord of the opener besides disconnecting from the garage door. These rules are compulsory for modern automatic garage doors but with the older versions of garage door, you will not need to turn off the energy circuits or remove the fuse to turn off the power supply.

Look closely at the broken spring before buying a new one to ensure that you are getting the right type of spring. Inspect both of them closely to confirm that they are the same dimensions, size, and type. Don’t touch the winding cones of the new spring and avoid grabbing it. You may use any good writing instrument to mark the particular torsion shaft ends. It is important because it helps you to maintain the balance of the garage door while replacing the broken spring. It is also recommended that test the alignment of the garage door when you have finished the job of installing a new garage door torsion spring.

Wind the spring off by unfastening the nuts and bolts which hold the torsion cones and brackets together and then quickly remove the bolts. After completing this procedure, it is time to remove the old spring, install a new one along with re-mounting the hardware. After accomplished this step, it is time to wind up the newly installed spring. Once you have finished this task, you need to make sure that the garage door is properly aligned. In order to avoid hard operations and frictions, you will have to apply some good quality lubricants.

Once you have confirmed that the garage door is balanced and all the hardware is properly tightened, it is time to reconnect the opener once again. It is not wrong that the garage door is not a toy to play with. But you will have to open and close the garage door a few times to ensure it is working completely. Remember, replacing a garage door spring is not as easy as replacing the batteries of the remote. It can be a dangerous task of not handled properly. You could lose your limbs, hands, fingers, or even life. Therefore, it is always recommended that hire professional garage door experts to deal with broken garage door springs.